События от SChannel можна частенько увидеть в журнале System Windows сервера. Они сигнализируют о проблемах с SSL/TLS и обычно отображают код ошибки. Механизм журналирования является часттью протокола SSL/TLS.
Для получения детальных ведомостей журналирование SChannel должно быть включено. Как это сделать описывает соответствующая статья: http://support.microsoft.com/kb/260729
Эти события могут быть очень полезными при решении проблем связанных с SSL. Но к сожалению, не так много документации детально описывает коды ошибок событий SChannel.
Эти коды определены в TLS/SSL RFC для всех существующих версий протокола. Например, рассмотрим RFC 5246 (TLS 1.2). Этот RFC определяет коды ошибок для последней версии протокола.
Проверьте эту ссылку: http://tools.ietf.org/html/rfc5246#appendix-A.3
Ниже приведено часть RFC, которая определяет коды ошибок:
A.3. Alert Messages
enum { warning(1), fatal(2), (255) } AlertLevel;
enum {
close_notify(0),
unexpected_message(10),
bad_record_mac(20),
decryption_failed_RESERVED(21),
record_overflow(22),
decompression_failure(30),
handshake_failure(40),
no_certificate_RESERVED(41),
bad_certificate(42),
unsupported_certificate(43),
certificate_revoked(44),
certificate_expired(45),
certificate_unknown(46),
illegal_parameter(47),
unknown_ca(48),
access_denied(49),
decode_error(50),
decrypt_error(51),
export_restriction_RESERVED(60),
protocol_version(70),
insufficient_security(71),
internal_error(80),
user_canceled(90),
no_renegotiation(100),
unsupported_extension(110), /* new */
(255)
} AlertDescription;
struct {
AlertLevel level;
AlertDescription description;
} Alert;
Эта MSDN статья также описывает эти коды: http://technet.microsoft.com/en-us/library/cc783349%28v=ws.10%29.aspx
Таблиця ниже объединяет в себе материалы MSDN с информацией RFC:
| Alert Code | Alert Message |
Description |
| 0 | close_notify | Notifies the recipient that the sender will not send any more messages on this connection. |
| 10 | unexpected_message | Received an inappropriate message This alert should never be observed in communication between proper implementations. This message is always fatal. |
| 20 | bad_record_mac | Received a record with an incorrect MAC. This message is always fatal. |
| 21 | decryption_failed | Decryption of a TLSCiphertext record is decrypted in an invalid way: either it was not an even multiple of the block length or its padding values, when checked, were not correct. This message is always fatal. |
| 22 | record_overflow | Received a TLSCiphertext record which had a length more than 2^14+2048 bytes, or a record decrypted to a TLSCompressed record with more than 2^14+1024 bytes. This message is always fatal. |
| 30 | decompression_failure | Received improper input, such as data that would expand to excessive length, from the decompression function. This message is always fatal. |
| 40 | handshake_failure | Indicates that the sender was unable to negotiate an acceptable set of security parameters given the options available. This is a fatal error. |
| 42 | bad_certificate | There is a problem with the certificate, for example, a certificate is corrupt, or a certificate contains signatures that cannot be verified. |
| 43 | unsupported_certificate | Received an unsupported certificate type. |
| 44 | certificate_revoked | Received a certificate that was revoked by its signer. |
| 45 | certificate_expired | Received a certificate has expired or is not currently valid. |
| 46 | certificate_unknown | An unspecified issue took place while processing the certificate that made it unacceptable. |
| 47 | illegal_parameter | Violated security parameters, such as a field in the handshake was out of range or inconsistent with other fields. This is always fatal. |
| 48 | unknown_ca | Received a valid certificate chain or partial chain, but the certificate was not accepted because the CA certificate could not be located or could not be matched with a known, trusted CA. This message is always fatal. |
| 49 | access_denied | Received a valid certificate, but when access control was applied, the sender did not proceed with negotiation. This message is always fatal. |
| 50 | decode_error | A message could not be decoded because some field was out of the specified range or the length of the message was incorrect. This message is always fatal. |
| 51 | decrypt_error | Failed handshake cryptographic operation, including being unable to correctly verify a signature, decrypt a key exchange, or validate a finished message. |
| 60 | export_restriction | Detected a negotiation that was not in compliance with export restrictions; for example, attempting to transfer a 1024 bit ephemeral RSA key for the RSA_EXPORT handshake method. This message is always fatal. |
| 70 | protocol_version | The protocol version the client attempted to negotiate is recognized, but not supported. For example, old protocol versions might be avoided for security reasons. This message is always fatal. |
| 71 | insufficient_security | Failed negotiation specifically because the server requires ciphers more secure than those supported by the client. Returned instead of handshake_failure. This message is always fatal. |
| 80 | internal_error | An internal error unrelated to the peer or the correctness of the protocol makes it impossible to continue, such as a memory allocation failure. The error is not related to protocol. This message is always fatal. |
| 90 | user_cancelled | Cancelled handshake for a reason that is unrelated to a protocol failure. If the user cancels an operation after the handshake is complete, just closing the connection by sending a close_notify is more appropriate. This alert should be followed by a close_notify. This message is generally a warning. |
| 100 | no_renegotiation | Sent by the client in response to a hello request or sent by the server in response to a client hello after initial handshaking. Either of these would normally lead to renegotiation; when that is not appropriate, the recipient should respond with this alert; at that point, the original requester can decide whether to proceed with the connection. One case where this would be appropriate would be where a server has spawned a process to satisfy a request; the process might receive security parameters (key length, authentication, and so on) at start-up and it might be difficult to communicate changes to these parameters after that point. This message is always a warning. |
| 255 | unsupported_extension |
Надеюсь информация окажется полезной при решении ошибок TLS/SSL!
